Panel lamp, as the name suggests, is the appearance of the surface of the surface.The LED panel light is a high -end indoor lighting lamps. The outer frame is made of aluminum alloy anode oxidation. The light source is LED. The entire lamp design is beautifully designed and luxurious.Beauty feelings.
Panel lamp production
LED panel light manufacturing tool: 1 tip mouth pliers or diagonal tongs, temperature -adjusting electric iron with ground wire, anti -static bracelet, nail cutting, high -quality fine welding wire, high -quality rosin, AB glue, preferably a DC current table 50mA 50mAof.Choose LED panel lights: LED panel lights should be highly bright. The brightness of the astigmatism should be more than 1200mcd, the angle is 120 degrees, and the concentricity is more than 20000mcd.Install the LED panel light; install the circuit board facing up, put the LED panel light poles in the direction of the polarity of the LED panel light, pay attention to the long foot is positive, the short foot is the negative electrode, the straw hat -shaped hat is plane.EssenceWelding: Welding should be used with a 30W soldering iron and ground wire. The welding temperature is controlled within 240 degrees, and the time cannot exceed 2 seconds.After welding, use the nails to cut the long pins.
Panel lamp installation
1. Suspension type: First install the suspension component on the back of the LED panel light, and then connect the lane rope.Consumers must pay attention to inquiries to understand whether the suspension component is the standard accessory of the manufacturer or the purchase of it.2. The ceiling type: first hit a few screw holes on the ceiling, and then slide the LED panel light into the ceiling box, fix the three sides.Then slide the panel light inside, and then fix the screw fixing frame on the fourth side.Convenient and simple and time -saving.3. Embedded formula: First install sheet metal slots on the ceiling, and then fix a few brackets that protrudes outward on the back of the LED panel light, and then put the panel light in, so that the bracket and the sheet metal slot on the ceiling are consistent.Fixed on the ceiling.However, because the thickness of various ceilings is different, the height between the light surface and the bracket needs to be adjusted, otherwise it will cause the LED panel light to be higher or lower than the surface of the ceiling.
Panel lamp specification book
Panel lamp structure
The LED surface light source structure mainly includes the appearance structure of the aluminum framework of the following materials, and the main structure of LED heat dissipation -generally use Al6063, aluminum squeeze, low cost in the early stage, beautiful surface treatment, and good heat dissipation effect.The diffuser boards uniformly spread the light of the light guide board, and it also plays the role of blocking outlets -the diffuser plate generally uses the Acklie 2.0 plate or PC material. The cost of acrylic is low and the light transmission rate is slightly higher than the PC.The anti -aging performance is weak, the price of PC is slightly expensive, but the anti -aging performance is strong.The light efficiency of the light guide plate light guide plate is very large in the outlets, followed by the selection of the board, but it is also wrong to blindly pursue the brands board. As long as the highlights of the light transmission rate are not the problem, it is actually possible.Anti -light paper reflects the remaining light on the back of the light guide plate -usually RW250.The rear cover sealing lamp body -generally AL aluminum, the overall texture is strong, and it can play a little heat dissipation effect.LED light sources generally use 3528 and some people also use 5630 and 5050.
Panel lamp price

Related tags： Houseware