The packaging machine is also called a bundle machine. The packaging machine is a machine using the packaging with a wrapped product or packaging piece, and then tightened and the two ends are connected to the materials connected by the thermal effects or use of the bag.Here are introductions to the workflow of the packaging machine and the maintenance and maintenance strategy of the packing machine.
How to use the package machine
(1) Burst: The packaging belt is bundled with a pneumatic packing machine, and the part of the left hand is held in the overlapping part, leaving about 300mm at the tail, and gently pulled the remaining part with the right hand.
Put the packing band: Hold the handle and tensor in the right hand (to ensure that the tight wheel and the pressure plate are opened to the largest), and insert the upper and lower parts of the packaging belt into the packing machine at the same time.
Note: The overlapping part of the packaging band of the pneumatic packing machine must be separated by a fixed -cut knife: loose the tightner (the tight wheel is clamped tightly).
(2) Tighten the packing belt: Press the tension switch (right side) with your right thumb and switch until the packaging belt is completely tightened.
(3) Vibration and cutting: Use your right thumb to hold the vibration switch (red) until the packaging band is cut and melted
Note: Press the vibration switching pole of the pneumatic packaging machine until the vibration timer stops automatically.
(4) Remove the packing belt: Press the handle and tensor in the right hand, press the switch to the switch with the small finger of the right hand until the packing belt is loosened from the tight wheel.Tighten the handle and tensor to move the tools from the packaging.
Packing machine maintenance guide
The maintenance and lubrication of the packaging machine: The maintenance and lubrication of the machine can be carried out regularly. First, pay attention to keep the machine dry. Do not let it rain, or put water on it.
Provide reference here:
(1) Remove the dandruff or dirt in the machine once a week.
(2) Once once a month, the skateboards and mid -knife are lubricated and lubricated at the previous section.
(3) After the above two maintenance is done every three months, add some (shaft, heart) and bearing at a time.
(4) Supplement the motor oil every two years.
(5) Pay attention to several parts.B. All belts.C. Play slide and surroundings.
(6) Do not add too much every time you refuel, so as not to fail the micro -switch due to immersion.
Precautions
1. Please confirm the power supply used by the machine. Do not plug the wrong power. This machine uses a three -phase and four -line system. The flower line is the grounding of the ground, which is used for leakage protection.
2. Do not pass your head through the runway of the strap during operation.
3. Do not touch the heating film directly with your hands.
4. Do not rinse the machine with water. When the workplace is humid, the operator should not work barefoot.
5. When the machine is not used, please roll the tape in the storage band back to the band to avoid deformation at the next use.
6. Do not stick oil on the surface of the roller.
7. Remember to unplug the power when the machine is not used.
8. Do not replace the parts on the machine at will.
9. The main parts should be lubricated with oil.

Related tags： Machinery