The network wire pliers are used to stuck the BNC jacket jacket and base. It has a hexagonal gap for the pressure line. Generally, this type of piping also has the function of stripping and cutting lines at the same time.San uses network wire pliers, with many functions and durable durability. It is an information age and modern family standing tools.
How to use network wire clamping
The network cable wiring standards are divided into 568A and 568B.Different standards show 568A on different line sequences: white green, green, white orange, blue, white and blue, orange, white brown, brown
568B: white orange, orange, white green, blue, white and blue, green, white brown, brown
This sequence refers to the launch of the crystal head, the shot is outward, and the metal feet are facing themselves from left to right.
First peel the outer skin of the network wire with a mesh (be careful not to cut the core inside).Some mesh pliers are divided into pressing and peeling. If there are stripping ports, the thread is stuffed into the thread to peel the thread skin without harming the core of the wire. If there is no threading, be careful.After peeling the thread skin, there were eight pairs of four pairs of pairs of one -to -one pairs of one -to -one pair, and each pair of lines were divided into lines one by one.Then arrange in the order of standards, and then arrange the line into a row of fingers and pull straight, and then insert these eight lines into the crystal head.Put your head into the perial port on the mesh pliers. Be careful not to let the wire leave out, and finally press down the net pliers.Generally, a good crystal head is pressed when it is pressed. It is pressed. The poor quality can only be pressed hard.If it can be pulled out, it is not pressed.It is enough to take a 1cm of the general wire core. The crystal head can hold the outer skin.
How to repair network cable pliers
1. Knock on the head of the network cable. If you do n’t do it, it is recommended to buy one again and buy it.
2. Network pliers maintenance tool set Crystal head pressure wire tie tinger, network cable clamp quality main point:
(1) The gap between the upper and lower hands should be small, the cutting line can be flat, the poor quality steel plate is thin, and the gap is very large. When the line is cut, the upper and lower swings are deformed.
(2) The cutting of the knife line must be flat, and it must be treated with heat, and the hardness is up to standard.

Related tags： Machinery