There will be a lot of turning in the driving of daily life, and there are some techniques in corner driving. There are also some techniques that need to pay attention to it.Below, let Xiaobian tell you some skills of the car turning.Elastic
Some techniques of the car curve turning
There will be a lot of turning in the driving of daily life, and there are some techniques in corner driving. There are also some techniques that need to pay attention to it.Below, let Xiaobian tell you some skills of the car turning.China
Turning route: outer side -inner side -outer side
When turning, if you want to quickly use the corner and do not want to produce too much centrifugal power, you must make full use of the width of the road and try to turn it with the large arc of straight lines.Enter the curve outside the outside, and when you go to the inner side of the curve, you should drive on the inside of the curve on the inner side of the curve. After the top of the curve is overOn the outside of the curve, the curve is driven out of the outer side of the curve, that is, when the corner, you must choose a "outer -inner -outside" turning route.
Turning principle: Slowly enter the oil and get out quickly
When you have not entered the corner, when you still keep the straight line, you should step on the brakes to slow down the car. If the curve is relatively large, it should be further reduced. At the same time, you need to lower it.Turning routes and correction directions, and then step on the oil door to simply turn the car; when you see the end point of the curve, return the steering wheel back to positive. After confirming the safety of the road conditions, you can quickly get out of the tanker.
Step/Method
1. How to pass the uphill curve
When passing up the uphill curve, you should loosen the throttle before entering the curve, so that the vehicle enters the curve at the outside of the curve at a faster speed, and then reduce the gear of the gear or two gears. Then select the route and correct the direction of correction directionAt the same time, lightly click the throttle; after passing the top of the curve, cut back the outer side of the curve, and at the same time increase the throttle, and finally drive out of the curve by leaning on the outer side of the curve.
2. How to pass the downhill curve
When entering the curve through the curve, you should loosen the accelerator and step on the brakes before entering the curve, slow down the vehicle to slow down, and reduce the gear position first or second gear. ThenBe curve, then loose the brakes and select the route and correction direction; after passing the top of the curve, cut back the outer side of the curve, lightly click the throttle, and finally drive out of the curve by leaning on the outer side of the curve.
How to pass the blind zone curve
The blind zone curve is a curve that cannot be seen.When driving on the blind zone curve, the speed of the vehicle must be reduced first because the traffic situation at the end of the curve cannot be seen, and it cannot be driving in a normal curve.In order to avoid or occur in the vehicle, you must drive by the side of the road. When passing through the left curve, the car should be driving along the outer side of the curve. When passing through the right curve, the car should drive along the inner side of the curve.Once you see the exit of the curve, you can change the lane, correct the direction, and follow the method of the front side, the inner and lateral side, and the gallery door accelerates away from the curve.

Related tags： Auto Accessories