Driving out, I believe many people often have it.However, in case your car has some small problems that need to be dealt with urgently, so what do you need to do? Below, Xiaobian lists several common problems and ...
Method for emergency vehicle emergency situation
Driving out, I believe many people often have it.However, in case your car has some small problems that need to be dealt with urgently, so what do you need to do? Below, Xiaobian lists several common problems and how to deal with it correctly.China
1. Engine flameout or engine failure
1. When the engine is turned off, it will seriously affect the control of the vehicle.
2. Pay attention to the loss of brake booster, and use more strength than usual to pick up the brakes.
3. Power steering assistance can also lose effect, and you need to use greater strength than usual to turn the steering wheel.
4. Personnel on the car should get out of the car to the safe area and wait for road rescue.
2. Water temperature is too high
If the temperature of the cooling water is too high, the following suggestions should be taken:
1. Hurry up and stop the car in a safe place.
2. Check whether the engine compartment has steam.
3. If there is no steam, open the hood to cool down the engine compartment in the engine operation situation.
4. If there is a steam emerge, you should wait until the steam is emerging, and then open the hood to cool.
5. Confirm whether the cooling fan is running. If it does not run, immediately turn the engine to the engine and go to the service plant for maintenance.
6. After the engine is turned off, please do not open the water tank lid directly. After the temperature of the cooling water is cooled, you can open the water tank cover to observe the cooling water state.
7. When the engine is still hot, the cooling water cannot be added directly, and the rapid cooling may cause the engine to damage.
3. The connection method when the battery is deadlocked
1. In addition to the positive and negative pole of the vehicle battery, do not touch other parts of the body.
2. First connect to the positive electrode of the two -car battery with a crossing line.
3. Use another clip of another cross -wiring to clamp the negative electrode of the rescue vehicle battery. The other clip is on the iron part of the rescued vehicle (no tram) (the negative electrode of the battery).
4. Start the rescue vehicle first, charge the battery for one or two minutes, then step on the accelerator to maintain the medium speed, and then start the rescued vehicle.At this time, special attention should be paid that if the engine of the rescue car is not easy to start, it should still be launched for 10-15 seconds before stopping (because the motor is very large in the instant power, it can reach 200 ~ 300 amp.The intermittent start -up method that is started again. The wires are prone to overheating, the battery is easy to be collapsed, and the voltage of the ignition system will be reduced, which will not be easy to launch the engine).
5. After being launched by the rescue vehicle engine, first disassemble the clip of the negative electrode, and then remove the positive pole.
4. Engine oil pressure alert lights are on
1. When the engine oil lamp is lit, the driving should be stopped first and the car is stopped to the side of the road. It may be caused by insufficient oil volume. You can check whether the engine oil is sufficient. If you find insufficient, you should replenish immediately.
2. If the engine oil is found enough, the engine oil lamp continues to light up, and the repair shop should be notified immediately to prohibit the operation of the engine from continuing the cause without determining the cause, so as not to severely damage the engine.
5. brake warning light
The brake system warning lights are on, and the hand brakes should be released first. If the hand brakes have been released, but the lights continue to light up, indicating that the brake system is faulty, and the repair shop should be notified immediately for inspection.
6. Battery warning light
The battery (or generator) warning lights are on, indicating that the charging system cannot be charged.From the battery warning light to the battery power, it can last about 25 minutes.(In the case of no other power consumption)
The above is an emergency treatment method. It is recommended to consult professionals and then take further treatment measures to avoid continuing driving to expand losses or cause hidden safety hazards!

Related tags： Auto Accessories