Plastic water faucet, as the name suggests, is the product material of the plastic.
Plastic water faucet leaks water
The most common water leakage solution is to use the pliers to rotate the faucet counterclockwise. At the screw fixing, the clockwise wraps five to six laps to stop the water -stop tape, and then the plastic water faucet can be installed clockwise.Later method.If the axis pads are worn, the leakage is caused, and a tiger pliers can be used to remove the lower cover, and the axis cushion is clamped with a gardenia. It is good to replace a new one. Generally, it will be sold for axle cushion.If you want to replace the triangle sealing pad, you can rotate the screws on the bolt head with a screwdriver. After removing it, remove the cover. The triangle seal is on the inside of the cover.If the phenomenon of leakage of the binding area is serious, just use a screwdriver to tighten the cover nut. If the problem cannot be solved, then the U -shaped sealing cushion has been replaced with a new one.The failure of the water stop disk is not easy to repair, and the faucet needs to be completely disassembled to clean up. This kind of failure is mostly because the local tap water is not clean enough to clean the memory gravel.If you find that the rubber pad is damaged, be sure to replace it immediately.
Plastic water faucet cant twist
There are several possibilities: 1. The torque value of the faucet is installed, causing the sticky and cannot be removed.2. Plastic water faucet material does not meet the standard.3. The water faucet has been used for too long and aged.
Plastic water faucet installation
Before installation, you need to prepare related tools, such as adhesive, sawing, wooden sticks, etc.The sticky glue is used to make the plastic faucet closely connected with the pipes they are in contact with, so that it will not fall off.The wooden stick is used to apply sticky glue to the position that should be coated with the faucet of the plastic water.The saw is used to adjust its length.When installing the faucet of plastic water, the impurities in the pipeline need to be cleared to avoid blocking.During the installation, the thread connection of the plastic water faucet should be aimed at the required pipes required for installation, and then slowly tighten the work to make the thread connection completely hidden in the pipeline.After the installation is completed, it needs to be static to make the sticky glue solidify.And should also clean the surface of the plastic water faucet to keep it clean.After its solidification work is completed, when the faucet is used for the first time, it does not need to apply a lot of effort to its switch. It only needs to gently twist its switch.Check whether it can pass the water normally. After the faucet is closed, whether it is still dripping in the mouth and whether the dripping water is normal, and check whether the installation of the plastic faucet is successful.
Plastic water faucet price
The price is different, choose according to your needs.The plastic water faucet depends on what brand you choose. The price is different, usually a few yuan.
How about plastic water faucet?
Temporary use, plastic water faucets are more practical, general construction sites, rental houses are more practical.However, it is recommended that the practical copper water faucet is better, and the overall is the most economical.

Related tags： news