Solar electromagnetic valve is an industrial equipment controlled by electromagnetic control. It is an automated basic element used to control the fluid. It belongs to a actuator and is not limited to hydraulic and pneumatic.Used to adjust the direction, flow, speed and other parameters of the medium in the industrial control system.The solenoid valve can cooperate with different circuits to achieve the expected control, and the accuracy and flexibility of the control can be guaranteed.
Solar electromagnetic valves are not water
Solution: 1. Remove the solar valve close to the solar energy and the surface to the water. If the water is not out of the water, check the solenoid valve and table.2. If the solenoid valve and the table are fine, that is, the pipe is leaking or blocked, and the maintenance is OK.Or low water.If the water pressure is low, it is recommended to add an automatic pressure -booster pump, and the prestige can.The solenoid valve cable cannot be disassembled. You should have the two lines of the solenoid valve. You can connect the light bulbs. If there is an electric light bulb, it will show that the solenoid valve is broken.If the bulb is not bright, the controller is broken.If you dont work, remove the solenoid valve and replace it with a normal valve.
Solar electromagnetic valve installation
1. Before installing, rinse the pipeline of the solar energy and clean the impurities in the pipeline.2. If solar energy uses water tower water, then the solenoid valve that matches the water pressure of the water tower must be selected, otherwise there may be a phenomenon that cannot be put on the water or the amount of water is too small.3. Before installing, conduct a comprehensive inspection of the solenoid valve. Check whether the labeling voltage of the solenoid valve is consistent with the voltage of the power supply, whether the various parts of the valve body are intact, whether the filter is complete, no damage, and the direction of the water flow and the solenoid valveIs the direction of labeling consistent?4. The solenoid valve should be installed in a place where it is easy to repair indoors. The choice of location cannot cause other joint losses. Pay attention to sunscreen and cold protection. The coils should be facing up.
How much is solar electromagnetic valve
The price is around 300 yuan.
Principle
The solar electromagnetic valve is actually a switch inside the device. It controls the work through the internal sensor and motherboard. When the internal sensor finds that the water level in the solar box is lower than the specified water level, the motherboard begins to provide voltage to the solenoid valve to allow the electromagnetic to allow the electromagnetic valveThe coil of the valve can open the valve through the voltage, and the solar energy can be performed. When the water level of the sensor tested to the solar water tank reaches the prescribed water level, the motherboard will stop supplying voltage to the solenoid valve.The water process.

Related tags： news