Hand -wash pot cabinets can generally be divided into two forms: independent hand -toas and desktop washing pots.The style of the independent hand washing pot cabinet is very beautiful. At the same time, it occupies a small place, good flexibility, and is particularly suitable for bathrooms with a large space area.However, it must be equipped with other accessories, such as small pieces such as mirror boxes, which can be used to make full use of empty positions around the washbasin to place some toiletries or some small daily necessities.
Smaller of handwashing pot cabinets
The height of the washbasin should not exceed 80 cm.The size of the floor cabinet is between 60 and 75 cm.The size of the hanging cabinet is between 50 and 60 cm.
Hand -wash pot cabinet price
Different brands, different materials, different specifications, and different prices, the general price is about 400-1200 yuan.
Hand -wash pot cabinet combination
Step of the combination of hand -wash basin cabinets: 1. Process process: Find line positioning → frame, frame installation → partition, fulcrum installation → cabinet fan installation 2, find line positioning: use the indoor unified standard high line before plastering, according to the design according to the design, according to the designProcessing hand -washing pot cabinet required by the construction diagram.3. Frames and frame installation: The frame and frame should be performed before the indoor plastering. After the installation is installed in the correct position, the two nails of each fixing part of the frame on both sides and the wood brick nails are fixed, and the nail cap shall not be exposed.If the partition wall is a fixing concrete or light -quality partition wall, it should be fixed according to the design requirements.If there is no requirement, you can pre-drill 5mm holes, 70-100mm deep, and embed the wooden wedge adhesive in the hole in advance, and then install it in the hole and install the fixed cabinet.4. Installation of the cabinet partition: Construct a separate parts (rack) according to the level of the elevation position and requirements of the construction diagram.The fulcrum of the wooden partition is generally nailing the fulcrum wooden bricks on the wall. The concrete partition is generally a pyrine -shaped iron or a corner steel bracket.5. Cabinet fan installation: 5.1 Press the installation position of the fan to determine the hardware model and the direction of the opening fan. Generally, the right fan of the opening direction should be used as the cover fan.5.2 Check the mouth size of the box: the height of the frame of the frame; the width of the frame of the frame should be scratched between the upper, middle and lower points between the frames on both sides, and fixed the line at the corresponding part of the fan.

Related tags： news