HOME > NEWSarticle

What is the principle of pumping toilet 2024-07-15 12:22:54 internet

The pumping toilet is composed of the following main parts: water inlet pipe, outlet pipe, water seepage pipe, water plug (water inlet and water outlet), floating ball, water release knob and leverage, water tank, water tank, stool (bending pipe connecting the water tank)EssenceThe basic principle of pumping toilet is to use the gravity of water to convert the potential energy of water into the kinetic energy of water, thereby wrapping the dirt into the sewer pipe.
Pump to a toilet installation
The main points of installation of toilet installation 1. Check the ground level of the toilet to be installed soon. If it is found to be tilted, you can install it after adjusting it to the level; 2. Check the sewage pipeline of the toilet before installation.Miscellaneous objects; 3. The height of 2-5 mm higher than the ground at the water port;
Drawing toilet size
The standard of the toilet size is the pit distance, which means that the distance between the pits from the wall is 200mm, 300mm, and 400mm.Most people use a 300mm pit distance.
Principle
Working principle of pumping toilet: Water enters the water tank by installing the pipes with an angle valve. As the level continues to rise, the floating ball will rise together. When the floating ball reaches a certain height, it will be closed into the pipeline (mainly through the graph of the figure (mainly through the figure.The shown water -stop rubber ring was closed), and the water tank was no longer replenished.When pressing the handle of the water, it will affect the water -stop rubber circle in the lower part of the water tank to open it. At this time, the water will enter the toilet seat.The principle of specific pumping water is as follows:
Dumping toilet brand
Pumping toilet brand: 1. Midea 2, Dongpeng 3, JOMOO/Jiu Mu 4. Joyou/Zhongyu 5, Mirang 6, American Aite 7, Australia 8, Binks 9, Obel 10, Arrow/Arrow
Dumping toilet price
What should I do if I pump the toilet leak?
1) The common cause of leakage to the toilet is because the hemispherical rubber cover with the sealing water outlet is lighter. After the water tank is leaked, the water tank is not tight enough to leak water when it falls.The processing method is to bundle a little heavy objects on the connecting rods connecting the rubber cover, such as large nuts, toothpaste skin, etc., pay attention to the bundle should be as close to the rubber cover as much as possible, so that the rubber cover is more likely to cover the water.Essence2) If the parts inside the water tank are aged, you need to replace the parts quickly. If the toilet and the sewer are leaked, you need to reinstall the toilet and re -seal.
What should I do if the toilet is blocked?
1: In fact, you can find a half -inch wide bamboo strip into the toilet to dredge the problem 2: Many times the toilet flushes more water, especially if it is soluble or can be soluble or can be available in soil and paper.If you break the items.If it is greasy, then rinse a pot of boiling water and turn it on it.3: Buy some pyrine, boil water to melt the alkali, pour into the toilet.After ten minutes, everything is through.4: Buy a bottle of cola and drink the drink before cutting off the cola bottle mouth and cutting it down and pouring it in the toilet with your hand and pumping up a few times.
Pumping toilet structure diagram
1. Analysis of the principle of the siphon in the pool siphon device: There is almost no change to pour a glass of water into the toilet. In fact, no matter how much water you pour it, it will not respond, because after the water pouring in the pond rises, it exceeds more than the water rising, which exceeds the water that exceeds more than surpassing more than the water rising.The water will be taken out of the siphon, and then a large barrel of water will be poured into the toilet. The siphon will be filled immediately, but you will find that the siphon phenomenon will make the water in the toilet enter the sewer immediately, and the toilet will beAfter the water is gone, the air will naturally enter the siphon, and then you will hear the sound, and the siphon process is completed.

Related tags: news