The full name of polystyrene board is called polystyrene foam board, also known as foam board or EPS board. It is a hair beads that contain volatile liquid foaming agents.The white solid with a closed hole structure is like a shockproof foam.
Polystylene board manufacturer
Beijing Juntao Weiye Technology Energy Co., Ltd. has a good evaluation.Beijing Juntao Weiye Technology Energy Co., Ltd. is located in Fangshan District, Beijing. It is mainly engaged in extrusion plates, polystyrazen boards, polystyrazhen board decorative lines, mortar, etc., and has been recognized by customers in the building materials — the insulation and thermal insulation materials industry.Essence
Polystyrene fire prevention level
There are three levels of B3, B2, and B1 (A -level can not be achieved in science and technology now).Among them, the B3 level is a normal board, that is, the fire is getting hot, and the fire is getting bigger and bigger; the B2 level is a slow burning class, that is, the fire will not grow after the fire will not burn the filter paper;Fire suffocation, that is, automatically goes off after leaving the fire, or go out within 10 seconds.
Polyzene board specification
The difference between polystyrene and extrusion plate
Compared with the polystyrene plate, the heat conduction coefficient is lower. Therefore, in terms of the thickness of the selection, it has a lot of advantages than polybine plates. It only requires a thin extrusion plate to replace a certain thickness polyophenylene.Board.Secondly, the pressure and compression of the extruded plate are higher than that of polystyrary boards. Because of this, the extruded plate can be used for the insulation of the roof and the insulation of the basement.However, compared to extruded plates, the following performance can play its own unique advantage in the following performance: First of all, its density is larger than the extrusion plate, so the structure is very dense, the quality is thick and breathable, and the surface smoothness is compared to the surface smoothness than the surface.The extrusion plate should be low, and you can successfully adhes up without too much bonding work.
Related tags: news