HOME > NEWSarticle

Principle of a water -saving device 2024-07-15 05:22:23 internet

The water -saving device is a kind of water -saving device through technological innovation on the basis of the existing ordinary water -saving.One water saving is the amount of water -saving water control water, and the other is to control the amount of water through the inductive device to reach the water saving.The water -saving function is the same as the function of ordinary water. It must have the function of saving water and maintaining water circulation.
Water -saving installation
1. Open the packaging when purchasing the water -saving device, and see if the matching installation tools are complete. 2. Use a wrench to remove the original faucet, and then clean the interface with water to avoid poor contact during installation.3. Open the faucet, drop the water -saving jacket, the flowing water is fog, at this time in a water -saving state.Check whether the water is normal 4. If the water is very small, after eliminating other external factors, you can repeatedly push the water -saving jacket several times when the faucet is opened;net.Under normal circumstances, the filter is not blocked.Keep your precautions. Remember that you must close the sluice before installing.The screw buckle should be twisted and tighten to avoid dripping water.
Water -saving brand
Marco Polos water -saving toilet has always been very concerned, because the amount of water in the bathroom will be larger, and the siphon type is a highlight of Marco Polo.You can choose the activity time to buy, and you can enjoy a certain discount; ETL is a water -saving brand in the United States. Its faucet water -saving device is discounted.On the faucet, the water resources can be saved a lot. The single price is 30 yuan/piece, which is an economic practical water -saving.
Water -saving price
Price: 280 yuan/set of origin: Fuzhou brand: Zhiyuan Model: ZY101 1. Product introduction has the advantages of unmanned, clean and hygienic, not easy to block, and low maintenance rate.Schools, agencies, enterprises and troops are particularly applicable.Ordinary groove -type water rushing to the public toilet was washed by an automatic water tank.The most common is the siphon water tank (pictured).During the water inlet, stop the water and complete a cycle.In this way, the 24 -hour uninterrupted rinse is formed, and the waste of water is very serious.
Principle of a water -saving device
Principles of water saving: A) Streaming restrictions, that is, limit flow to reduce the use of water loss in the process of water (stipulates that the maximum traffic is not greater than 9 liters/minute) at 0.1MPa and the pipe diameter); b) shorten the faucet to the faucetOpen and turn off time to reduce the waste of water during the switching process; C) Ceramic sealing to reduce dripping.Main defects: The above three water -saving principles of A, B, and C are theoretically feasible, but in practice, the effect is not good.
Self -made water -saving
(1) The original water tank of the water -saving water saving toilet water saving device does not make any changes. It only takes a few minutes to install this water -saving "in the water tank, and an ordinary toilet can become a water -saving toilet.The water -saving device is milky white, consisting of two semi -circular plastics and a screw. Two semi -circulars are put together on the vertical pole of the toilet outlet.The effect of water.(2) Self -made water -saving water -saving device takes one mineral water bottle cap, cut out 18.5mm with scissors as a diameter circle, and in the center of the circular shape, a round hole with a diameter of 1mm is made.The more water -saving, the more 6 holes are recommended.Effective water saving is about 30%, and this water -saving (also known as a yearning water -saving water -saving) that it makes by itself solves the problem of complex technical structure and high cost.Suitable for faucet or shower head.It can be installed on the front or back end of the valve (water faucet) of the water inlet of the water inlet of the valve (water faucet). For water on the upper row, such as shower, washbasin, etc., it can save water.

Related tags: news