Watch knowledge: How to disassemble the Tudor watch tablet component? The method of watching the watch wheel component and the attachment on the plywood: 1. The screw of the lower plywood screw with the screw of the screw, and use the finger pliers to take the hem folder.2...
How to disassemble the Tudor Watch Shi Wheel Component?
Watch knowledge: How to disassemble the Tudor watch tablet component? The method of watching the watch wheel component and the attachment on the plywood: 1. The screw of the lower plywood screw with the screw of the screw, and use the finger pliers to take the hem folder.2. Hold the splint with a finger clamp, and put one end of the fast -slow needle inside and outside the intragling.3. Traveling is only required to be removed when the shaft is damaged, the hairscin dirt or severe deformation.4. When removing the shockproofer, the shock -proof spring is a hinge -type structure that can be used to use the stick tip of the rod needle to allocate the two sides from the groove.
1. Raise the screw of the plywood screw with the screw of the watch, remove it with a finger pliers, and then use the screw to insert the splint cutting groove with a gauge screw.After holding the fingerprint clamping the splint, move it outward, and then lift it up. At the same time, avoid the hairspring and the wrapping wheels to be hung up by other parts to prevent swimming deformity.After the watchs shaft birch is out of the shock -proof seat, the panels will be littricted by the panels.After disassembling the splint and the plaid component, place it, so as not to damage the shaft birch.
2. Hold the splint with a finger clamp, and put one end of the inside and outside of the fast -slow needle in the groove of the Ivic. This can prevent the fast -cut needle from getting out of the shock -proof seat when the outer punch is opened with a screw and the outer pinch.Can block the fast needle rotation (see Figure 1).After the fast and slow needle is opened, you can place the plywood slightly tilted on the edge of the anvil to use the screw to rotate the outer pile screw, but do not spin it. At the same timeOther molds and deformation of the scarf.If the outer pile cannot be removed, the outer piles can be used to push the outer pile with a stick needle, so that the swimming module is disassembled (see Figure 2).
3. Traveling is only required to be removed when the shaft is damaged, the hairscin dirt or severe deformation.The method of disassembling is: putting the rotor component on the anvil, so that the lower axis and dual disc components can be placed in the punching holes in a loose ground.At the gap in the pile), the bottom of the inner pile of the scarf was stretched, and the inner pile was prying the inner pile and the scarf parts were clawed away from the shaft.
4. When disassembling the shockproofer, the shock -proof spring is a hinge -type structure that can be used to use the stick tip of the stick tip to pass out one by one from the groove, open the shock -proof spring, and swing the panel in turn.Diamond can pour out.If the shockproof bowl cannot be separated from the drilling drill, the shockproof bowl can be placed on the round hole of the anvil. The round hole should be able to resist the edge of the shockproof bowl.The stick tip of the axis birch stretch into the drilling hole of the shockproof bowl and leave the drill.When the drill in the shockproof bowl is not easy to pour out, they can be soaked in gasoline brushes to separate them.
original:

Related tags： bags&jewelry