How to connect the phone line?Generally, the telephone line is 4 cores, but in fact, only 2 cores are needed. Different from the network line, the phone line can connect without the line order. As long as the phone is guaranteed to be the two contact films in the middle.You can use the telephone line or network cable. The phone line has a small requirements for the cable. Lets take a look today.
How to connect the phone line to the crystal head connection method
How to connect the telephone line? Below the four -core phone as an example to explain how the phone line is connected to the production process.
Tools/raw material crimping clamps, telephone crystal head RJ11, telephone line or network cable
Method/Step
1. First, use the scissors of the thread -cutting knife to tailor the phone line to use the plan to use.
2. Peel off the white protective layer of the telephone line and let the knife open the protective rubber on the phone.
3. Use the cutting line of the thread to cut the top of the phone line neatly. It should be noted that when cutting, it should be inserted horizontally, otherwise the length of the phone line will not affect the normal contact between the phone line and the crystal head.
4. After cutting, everyone should try to keep the cables as much as possible, and should avoid significantly moving or curved network cables, otherwise it may also lead to unevenness in several groups of cables that have been arranged and cut.
5. Insert the organic phone line into the crystal head.It should be noted that the crystal head has one direction of the crystal head, one direction of the pinch of the needle, so that the end of the needle is pointed at the direction of the needle, and the one with a square hole is facing itself.At this time, the far left is the first foot, the right is the fourth foot, and the rest is arranged in order.When inserting, pay attention to slowly insert 4 cables along the 4 wire grooves in the RJ-11 head at the same time, and insert it to the top of the wire groove.
6. After confirming that there is no error, you can insert the crystal head into the 6P tank of the threading thread. After inserting the crystal head, hold the tight thread tightly. If the strength is not enough, you can use both hands to press together.Make the crystal head protruding all the needles outside into the crystal and the head of the head, and you can hear a slight "snap" after the force.

Related tags： Appliances