The water dispenser is a device that raises or cools the barrel pure water (or mineral water) and is convenient for people to drink.Put a barrel water above the machine and use it with barrel water.The water dispenser is summarized into three types: warm, ice -heat, and ice temperature heat. The ice heat machine is divided into two types: semiconductor refrigerated water dispenser and compressed refrigeration water dispenser.
How to disinfect the water dispenser
People who drink barrels of water are pure water quality and are good for health.However, if the water supply session is not completely disinfected, it will also cause the secondary pollution of water quality.Even some manufacturers equipped by manufacturers may not be completely qualified for disinfection processing.
Specifically, the disinfection of the water dispenser should be divided into the following steps:
First, remove the power plug, remove the barrel, open the sewage pipe behind the water dispenser, and excrete the residual water, because the remaining water in the sewage pipe is the key to the secondary pollution of the water dispenser.Then, open all drinking water switches and water.
Second, clamp the alcohol cotton with a mule, and carefully wash the inner tendon of the water dispenser.The water dispensers inner bile is easy to accumulate bacteria because of direct contact with the air.Wipe with alcohol, you can remove the dirt above and prepare for the next step.
Third, dissolve the 300 ml disinfection agent into about 2 liters of water, fill the entire water dispensers inner bilots, and place it for 10-15 minutes.
4. Open all the switches of the water dispenser, including sewage pipes and water switchs, and cleaning disinfection.
Fifth, use 7-8 liters of water to continuously wash the entire cavity of the water dispenser, and open all switches and cleaning and rinse liquid.Some people are not enough to rinse with only 1 liter of water, which will cause disinfection to remain in the water dispenser.
6. Wipe the back wall of the switch with alcohol cotton. When the water is used with a cup, it is easy to touch the rear wall of the water dispensers switch, and you must not scrub it with rags.
After the disinfection of the water dispenser, there may also be a small amount of disinfection liquid residue and cannot be consumed immediately.You should put a glass of water first to smell the chlorine smell.If so, you should put water again until you cant smell the chlorine smell.
How to maintain a water dispenser
(1) Put a lightly and lightly handle machine. When moving the refrigerated water dispenser, you should try to move upright as much as possible. If it is tilted, it must not be greater than 45 degrees, and it must be restrained after transporting for a period of time before it can be restored for a period of time before it canWork.
(2) When using the water dispenser for the first time, clean the water dispenser and the pipeline of the water dispenser, and then turn on the drain valve to tighten the drain valve after the remaining water in the machine.After adding a large bottle of water, turn on the hot water faucet. After the water flows out, the power supply can be inserted, and the heating switch can be opened to avoid dry burning and extend the life of the machine.
(3) Discontinue for a long time for drinking water. Please turn off the machine switch and pull off the power plug. Then turn on the drain valve, the remaining water in the discharge machine, and then tighten the drain valve (please pay attention to hot water burns during the drainage process).
(4) It is best to disconnect the power when it is not used at night, which can save energy and ensure the safety of no one.
(5) During the use of the machine, it is recommended to clean and disinfect every 3 months according to the specific situation. For one year, professional maintenance personnel can be asked to clean the smart seats and inner lined.
(6) The water dispenser should be placed in a ventilated place to prevent humidity, avoid direct sunlight, and stay away from heating.It should not be placed at a place near the wall of about 15 cm away from the walls near valuable furniture and other household appliances to avoid splashing water damaged items.The water dispenser must be stable to prevent noise from the machine.
(7) Forbidden the surface of organic solvents such as gasoline.
(8) If the power cord is found to be damaged, the water dispenser must be changed to a special soft line or contacted the dealer.The machine must use a socket and leakage protector with a grounded device to prevent the shell from charging.
(9) Do not play next to the water dispenser. If you have necessary, you can replace the hot water faucet into a safe faucet to prevent the child from scalding.
(10) Do not put metal rods into the backboard fan window to avoid damaging the fan or causing electric shock; do not cover the fan ventilation window, so as not to damage the semiconductor refrigeration component due to poor exhaust air and poor heat dissipation, and cause adverse situations.
(11) The water dispenser with a compressor refrigerated. When the cooling power supply is disconnected, it must be started again after 3-5 minutes to extend the life of the machine.
(12) When pressing the faucet, do not excessively force, so as not to turn or damage the part of the hand.

Related tags： Appliances