As soon as the cold winter, it becomes very cold, at this time, the role of the heater is indispensable.Electric oil heater is a kind of heating tool we can use every day in winter, but there will also be some problems with long -term use. Therefore, understanding some maintenance methods can solve many problems for us.
Which is the best of electric heating oil tin and heater?
1. Compassion
The temperature of the electric heating oil rises slowly, but the entire room is evenly heated, and it does not affect the humidity of the room. It feels more comfortable.
The blowing of warm air will quickly take away the water in the room, which will make the population dry.
2. Power
Families that are too large in electric oil tin, and families with small meter capacity or low voltage cannot be used.
The power of the heater is generally relatively small, and the noise when booting is a headache.
3.
The heat emitted by the electric heating oil tin is large, and it can maintain a certain temperature after power off, suitable for places such as bedrooms, living rooms and offices.In addition, some products are also equipped with baking shelves at the top.Users can also bake clothes on it.
The warm air is soft, the temperature is fast, and it can only be used in a small range.In addition, PTC components generally have waterproof function, so it is suitable for use in the bathroom.
What should I do if the electric heating heater is not heated?
1. Check whether the power plug, socket, etc. are poor and the power cord is disconnected.If you only need to replace good, qualified power cords, plugs, or sockets.
2. The over -temperature fuse is dissolved. First check whether there is a short -circuit phenomenon in the load. If there is a short circuit, first exclude the short circuit source, and then replace the over -temperature dissolved foil.
3. The thermostat or switch is damaged. After using a multimeter to measure and judge, the damaged component is repaired and replaced.
4. The two electric heating pipes are damaged at the same time and can be replaced as a whole.
5. The oil heaters are less oil or no oil. If your electric heater is half the heat below, the above half of it is not hot, indicating that the oil may be missing.You can change the new oil by yourself. Oils requirements for oil are not very high, but generally do not advocate mixing oil. Mixed oil may cause the oil to deteriorate.
6. The electric heating oil contains thermal conductivity. The heating pipe is immersed in the thermal conductivity and passed it to the entire radiator through the thermal conductivity. In order to ensure that the heating pipe is not dried when heatingAfter the oil dumping, this switch will disconnect the power to protect the heating tube.If the oil toll -up and inverted switch fails, it may cause the oil heater to heal the partial failure, which will cause the electric heating heater that the electric heater cannot be heated. ThereforeThe dumping switch is sufficient.
Electric heating oil heater anti -roll switch repair steps
1. Anti -tilt switch is installed on the main panel lid of the oil. When the normal work is heavy hammer, it is vertical and downward. At this time, its contact is the connection state that can supply power to the electric heating pipe.
2. Before measuring the anti -roll switch, we first need to unplug the wiring of any one -terminal to accurately measure.
3. Put the multimeter to the gear of the measuring resistance of 200 ohms to measure the resistance between the two terminals of the anti -tilt switch.
4. The measurement of anti -tilt switch should be divided into two cases. One is to measure the state. At this time, the heavy hammer and the ground are not perpendicular to the ground.Indicates not connected.Another case is to measure the resistance between the two terminals in the state of the vertical ground. At this time, the contact of the dumping switch should be in a connected state.
5. If the multimeter is displayed 0 or nearly 0 in the resistance gear, it means that the resistance is zero. When the oil is placed normally, the value is correct, otherwise it will indicate that the dumping switch is damaged and the new dumping switch can be replaced.

Related tags： Appliances