How to prevent the inkjet head from blocking the nozzle head? The problem of nozzle head blocking during use in the process of use is mainly "preventive".To maintain the best way to work in the best working state of the nozzle is that you do some appropriate and effective daily maintenance of the nozzle every day, which will greatly reduce the possibility of nozzle blockage.Tips for use.Lets take a look together!
How to prevent the inkww vimer from blocking the nozzle head
After all the printing operations are completed every day, the nozzle is blocked to keep the nozzle and avoid blocking the nozzle due to the volatilization of the solvent -based ink.
1. Turn off the equipment power supply.
2. Wash the moisturizing sponge with a dedicated cleaning solution, and then pour the cleaning solution on the sponge to wet it.
3. Shift the head to the right at the right end and close the nozzle with the moisturizing sponge.
4. Keep this state for the equipment to spend the night.
Raper Torch Maintenance Guide
1. During the inkjet process, it is not hesitant to press the PAUSE key to suspend the printing operation without hesitation, and then use a vacuum cleaner or manual pump to make the ink spray from the nozzle to clean the nozzle.Spray some cleaning liquid on the surface of the nozzle and wash the residual ink.
Note: Do not use the manual air pump too hard, otherwise it will damage the nozzle due to excessive pressure.
2. Timely and decisive and thoroughly dealt with the slightly blocking of the nozzle. It is very important to keep the nozzle during a long time printing!
3. In addition, it is necessary to carefully check the situation of the nozzle and find the reason why the nozzle is blocked.
48 hours do not use inkjet machine processing method
If the device is expected to be not used for more than 48 hours, the ink in the nozzle must be cleaned, otherwise the ink in the nozzle will gradually be died due to the solvent, which will even cause irreversible damage to the nozzle.
The processing method is as follows:
1. Turn off the power supply of the inkww vimer.
2. Move the head of the machine to the left end to clean the position, and put a corrosion -resistant container under the nozzle to make it out of the installation and cleaning waste liquid.
3. Use a glass syringe to pull out or pour the ink in the ink tank directly, and then wash the parallel ink tank with a dedicated cleaning solution.
4. Unplug the ink supply tube (derived from the auxiliary ink tank), and then use a glass syringe to draw a 40ml special cleaning solution to clean the nozzle, and do it 2 times in total.Finally, do not blow the residual cleaning solution in the nozzle. Be sure to leave enough cleaning liquid inside the nozzle, because the cleaning solution can moisturize the nozzle.
5. Put the processed sprinkler into a clean corrosion -resistant container and seal (pretty good with plastic wrap) and can be stored for about 1 month after getting up.