The paper cutting machine is one of the indispensable equipment for each plastic factory, rubber box factory, and printing factories, but in the process of operating the paper machine, the safety problem of the operator cannot be ignored.In addition to some suggestions for the safety operation regulations, what is more vigilant is that security comes from the sense of crisis at all times, and the danger comes from paralysis.The following combined with theoretical practice operations, the operator of the paper cutting machine must comply with the procedures for operation.
What are the rules of the paper cutting machine
1. The operator must be familiar with the performance and safety points of the paper cutting machine.
2. Before work, the operator must wear work clothes, tighten the cuffs, and prohibit long hair, slippers, skirts, and jewelry operating machines.
3. Check out whether the optoelectronics protection switch of the paper cutting machine is normal and reliable each time it is turned on.Try the empty knife three times, observe whether there is a back knife, and find that the switch is strictly prohibited.
4. Before turning on, add the lubricating oil of all the lubrication points of the machine.Pay attention to the surrounding environment, whether someone is doing other maintenance work on the machine.
5. Check the operation of the machine and concentrate the lubrication system. The emergency stop buttons of each part are normal.
6. The top of the paper cutting machine is strictly forbidden to put tools and other objects on it (such as steel ruler, board hand, screwdriver)
7. When installing or disassembling paper cutting blades, manual operations should be used. After the main motor completely stops, the switch can be shifted to the switch switch position.
8. When adjusting the depth of the gum with the paper cutting machine, the paper cutting knife should be increased first, and then the depth of the adhesive strip is adjusted from shallow to deep to deeply.
9. After the blade is blunt, the blade should be replaced immediately. Do not continue to use it, so as to avoid excessive loads of the machine and cause damage to the parts.
10. The pressure regulation of the papermaker pressure paper is not allowed to be greater than 60kg/cm2.(Generally around 45).
Paper cutter blade replacement method
When changing the knife, first turn off the main motor, wait for about 2 minutes, and confirm that the transmission belt is completely stopped, and the two wooden knife swords (provided by the manufacturer) are placed under the blade, and the tailor switch on the switch panel is put on the switch panel.Select the switch to place the knife position "". The knife bed function selection switch must be cut in the tailoring position. Use the sleeve to rotate the band -end noodle nut to remove all the screws on the blade, and then use the inner hexagon wrench4mm, leave the knife device brakes away, rotate the knife device to put the blade smoothly on the two wooden knife swords, install two knife handles, remove the blade, pay attention to holding the blade to prevent the wounded.
Cutting paper maintenance skills
1. Before the start of the work (continue to work after the shift or halfway), check the main components of the paper cutting machine for inspection, and add lubricating oil.
2. After the work of each shift, do a cleaning work on the machine. Wipe the exposed rubbing surface and add the river oil lubricating oil.
3. In the case of normal two -class work, the paper cutting machine makes a comprehensive cleanup and inspection of the machine every two weeks.
4. If the paper cutting machine is stopped for a long time, you must wipe all the bright surfaces, apply rust oil, and cover the plastic cover to cover the whole machine.
5. If the paper cutting machine stops more than March or above, the moisture -proof paper should be covered on the rust oil.
6. When checking the disassembly paper cutting machine, it is forbidden to use inappropriate tools and use unreasonable operation methods.